Install wheel noting reference mark made on removal. When replacing brake pads, be sure to inspect brake discs (rotors) for wear. When brake pads have reached their wear limit, replace them. Rear brake pad, minimum thickness (without backing plate) ½ Alternatively, looking through brake caliper opening: Measure inner and outer rear brake pad thickness (distance between arrows). ½ Measure inner and outer front brake pad thickness (distance between arrows). See Lifting Vehicle in this repair group. Loosen wheel bolts slightly before raising vehicle. Before removing a wheel, mark it’s position in relation to brake rotor so wheel can be reinstalled in same position.

Remove wheel bolt caps and alloy wheel center cap as required. If using a lift or hoist, remove tool kit before raising vehicle. See Tire and wheel service in this repair group. The key for the locks is usually stored in the vehicle tool kit. Vehicles covered by this manual may use wheel locks. Checking the outer pad thickness can be accomplished without removing the wheels. To accurately check inner and outer brake pad thickness, it is necessary to remove the wheels. UNDER CAR MAINTENANCE Brake pads, checking Periodic maintenance of the brake system includes inspection of front and rear brake for pads thickness.

Make sure air filter is correctly installed and seated into housing.

Lower air filter housingĬlean filer housing and install new air filter. ½ Remove air filter element (13) from lower air filter housing (15). Remove upper part of air filter from bracket and pivot toward engine. Remove mounting screws (2) for upper air filter housing. Release hose clamp and disconnect hose (1). ½ Open retaining clips (4) and disconnect air intake hose.

Audi a4 haynes manual download free